Honeywell Galaxy 3-48C Instruccion De Instalación

MAX

3 

readers can only be configured into the Galaxy system from engineer mode.

Access engineer mode.Wire the MAX

3 

as per the instructions given in Figures 5-1 or 5-2

The MAX

3 

reader must be assigned as either an On-Line or a Stand-Alone module using option 63.2.2 =

On-Line: The MAX

3 

is fully integrated with the Galaxy system and communicates via the AB line,

sharing system resources and facilities.
1 =

Standalone (default): The MAX operates as an entirely independent unit.  The Galaxy does not

monitor the MAX

3

 for alarms, tampers or power failure.

1.

Connect power to the MAX

3

 as per Figure 5-1.

2.

Ensure that the MAX mode is enabled (option 63.2.1 = OPTIONS.MAX.MAX Mode).

3.

Select option 63.2.2 = OPTIONS.MAX.MAX Address and press the ent key; the Galaxy panel
may prompt (depending on model) for the AB line (1 – 4)) that is to be searched; select the line and
press the ent key. The Galaxy searches for the MAX

3

 with the highest address. New MAX

3

 readers

are addressed as 8 (standalone) by default.

4.

 reader: On locating the MAX

3

 address, the keypad prompts for the

OPERATING MODE of MAX

3

 to be assigned: select 0 = On-Line and press the ent key.

NOTE: If reprogramming an existing stand-alone reader, the system automatically selects the On-

Line operating mode.

The MAX

3 

can then be readdressed.  The keypad displays the current address of the MAX

3

 and the range of

valid addresses.  Enter the new MAX

3

 address and press the ent key; the Galaxy then reprograms the ad-

dress of the MAX

3

.  The keypad indicates the old and new MAX

3

 addresses and the status of the reprogram-

ming.
All new MAX

3

 readers default to address 7.

NOTE: It is recommended that when adding a reader, it is addressed as the lowest available number on the

line.

When the reprogramming is complete the MAX

3

 bleeps, the LEDs on the MAX

3

 switch off and the keypad

display returns to 2 = MAX Address.

5.

Exit engineer mode - engineer code + esc:  the keypad displays the message 1 MOD. ADDED -
esc=CONTINUE.  LED 2 on the MAX

3

 reader switches on.  Press the esc key; the keypad

returns to the unset banner.

If this message is not displayed, the MAX

3

 reader is not communicating with the control panel

and has not been configured into the system (LED 2 does not switch on).

1. The MAX

3

 reader will not operate until engineer mode is exited and the reader is configured into the

system.

2. All MAX

3

 doors must be closed, otherwise engineer mode cannot be exited.

6.

The on-line MAX

3

 reader is now configured into the system.