Hitachi Projector Accessories HAS-K250 Manual De Usuario
ENGLISH
13
HAS-K250
Attach the LCD projector to which the bracket (B) has been attached to the
adjusting block (Q).
Tighten the four M4 x 8 round head screws (H).
Tightening torque: 0.98 N•m (10 kgf•cm)
Connect the cables to the projector.
(B)
(Q)
(B)
(Q)
(H)
(LCD projector rear panel)
(LCD projector front panel)
Connect as shown in the above fi gure.
(H)
WARNING
■ Never use screws other than those designated.
Failure to heed this warning may cause the projector to fall or other hazard
Failure to heed this warning may cause the projector to fall or other hazard
resulting in damage or injury.
*#5-A'0)KPFF