Hitachi HDF-385H Manual De Usuario

1. Remove all packaging material. This includes the foam base and all

adhesive tapes holding the freezer accessoriesinside and
outside.

2. Inspect and remove any remains of packing, tape or printed

materials before powering on the freezer.

• Your freezer is designed for freestanding installation only.

It should not be recessed or built-in.

• Place the freezer on a floor,which is strong enough to support

it fully loaded.

• When moving the freezer, never tilt it more than 45-degree angle.

This could damage the compressor and the sealed system.

• If the freezer is tilted let it stand in an upright position for at least 24

hours prior to plugging. This is to allow the refrigerant to settle.

• To assure your freezer works at the maximum efficiency it

was designed for you should install it in a location where there
is proper air circulation, plumbing and electrical connections.

• The following are recommended clearances around the deep freezer:

Sides

100mm

Top

100mm

Back

100mm

Installing Your Freezer

Unpacking Your Freezer

Adjusting Your Freezer

Proper Air Circulation