Greenheck Fan Corp. Automobile Parts M8182 Manual De Usuario

120 v

280v
240v

Com.

White

Violet

Orange

Black

Transformer

Control Device

L1 (Hot)

Transformer

Yellow

Red

Blue

Com.

N.C.

  8.  Wire the actuator according to the
    appropriate wiring illustration that
    identifies the actuator’s electrical
    connections. Wiring should be per an
    approved project or job wiring diagram
    and must comply with all applicable
    electrical codes

Note: Tape or wire nut all unused leads.

9. Apply power to the actuator.

    The damper blades should fully open or
    close and return to the fail position when
    power is disconnected, if they do not,
    adjustments can be made by resetting
    the crankarm position on the damper or
    actuator shaft, or by adjusting the 3 in.
    dimension on the damper shaft crankarms.

Auxiliary Switch Wiring Connections
(All colors are tracers on white wire)

Model M9185 Wiring Connections

Note: This is a modulating actuator that

requires a control signal to operate.

Model M4182 Wiring Connections
Note: Model M8182 is a 24 Volt actuator
with no transformer. Connections must
be made directly to T1 and T2.

454200 Honeywell M4182, M8182, M9185 IOM

Rev. 5 August 2005

Electrical Ratings

Voltage

(V@ 50/60 Hz)

Current Draw

(A)

Power consumption

(W)

Without Transformer

.86

With Internal Transformer

120

.25

208

.14

240

.13

Controller Type: Two wire, on-off switching action

Auxiliary Switch Ratings (Amperes)

120V

240V

Full Load

7.2

3.6

Locked Rotor

43.2

21.6

Ratings for 40 VA pilot duty, 120/240 VAC on opposite contact