Graco 332574D - RS Gun Cutter Assemblies Manual De Usuario

Premature anvil or 
blade wear

Excessive tension between anvil and cutter 
head

Adjust Anvil to Cutter Head Tension, page 8

Cutter speed faster than necessary

Premature Blade or Anvil Wear, page 7

Roving binds up in 
Cutter

Obstruction in roving path 

Ensure the roving path is free from obstruction

Overspray/binder build up on internal com-
ponents

Clean components and reinstall the cover 

Resin on roving

Clean as necessary, keep roving away from 
resin and overspray.

Incorrect anvil to idler wheel tension

Adjust Anvil to Idler Tension, page 9

Incorrect anvil to cutter blade assembly ten-
sion

Adjust Anvil to Cutter Head Tension, page 8

Cutter blade assembly is worn out

Replace

Anvil is worn out

Replace

Cutter does not actu-
ate when the gun is 
triggered

Air supply to gun is shut off 

Open air supply

Speed control in off position

Adjust Cutter Speed, page 8

Quick release plunger stuck in 

Inspect, clean and lubricate, replace if neces-
sary

Incorrect anvil to idler wheel tension

Adjust Anvil to Idler Tension, page 9

Incorrect anvil to cutter blade assembly ten-
sion

Adjust Anvil to Cutter Head Tension, page 8

Cutter air valve stuck

Inspect and replace if necessary

Air motor is “locked up”

Add oil to air motor, page 10

Check for free rotation, replace if necessary 

Cutter is cutting long 
strands

Anvil to cutter blade tension is incorrect

Adjust Anvil to Cutter Head Tension, page 8

Anvil to blade tension lockdown is loose

Tighten the anvil to blade tension lockdown

Anvil is worn out

Replace Anvil, page 11

Cutter blade assembly is worn out

Replace Blades, page 12

Air motor spins but 
doesn't cut glass

Cutter head set screws (606) loose.

Apply medium strength thread sealant and 
tighten

Anvil to cutter blade tension is incorrect

Adjust Anvil to Cutter Head Tension, page 8

Air motor speed 
incorrect

Incoming air supply issues

Ensure proper air supply to gun, see Technical 
Data, page 27

Supply air volume too low

Ensure adequate air volume, see Technical 
Data, page 27

Air motor speed control set incorrectly

Adjust Cutter Speed, page 8

Anvil to cutter blade tension is too high

Adjust Anvil to Cutter Head Tension, page 8

Air blowing out oil hole

Air motor installed incorrectly, page 17

Cutter blade assembly is worn out

Replace Blades, page 12

Air motor exhaust filter plugged

Clean and replace as necessary, page ###