Genesis I.C.E. Genesis 6.1e Manual De Usuario
ver 1.0
3
3
absolute fidelity
1 A Quick Start Set-up Guide
Now that you have your new Genesis 6.1e loudspeaker system, we
realize that you can’t wait to hook it up and start playing! However,
please read this quick set-up guide (even if your dealer is setting it up for
you) before you proceed.
realize that you can’t wait to hook it up and start playing! However,
please read this quick set-up guide (even if your dealer is setting it up for
you) before you proceed.
1.1 Unpacking
Your loudspeakers will come to you in two large shipping cartons. The
cartons containing your speakers weigh over 90lbs (41kgs) each, so we
suggest a minimum of two strong people to move the speaker cartons
around. We will not be held liable for damage to either the speakers or
your backs during unpacking and setting up.
cartons containing your speakers weigh over 90lbs (41kgs) each, so we
suggest a minimum of two strong people to move the speaker cartons
around. We will not be held liable for damage to either the speakers or
your backs during unpacking and setting up.
The packaging is designed to ship the speakers vertically, and to be
unpacked horizontally. Please observe the “This Side Up” signs when
shipping and unpacking.
unpacked horizontally. Please observe the “This Side Up” signs when
shipping and unpacking.
The carton is designed to unfold to make it easy to remove the
speakers. With a sharp knife, cut the tape on the top and two ends of
the carton. The sides will fall apart revealing the speaker held in place by
a back support box, and two pieces of foam holding on to the top and
bottom of the speaker. You will also find the wire grill that will go on the
front of the speaker.
speakers. With a sharp knife, cut the tape on the top and two ends of
the carton. The sides will fall apart revealing the speaker held in place by
a back support box, and two pieces of foam holding on to the top and
bottom of the speaker. You will also find the wire grill that will go on the
front of the speaker.
Remove the foam on the bottom of the speakers, and slide the plastic
and foam wrapping off. Now, tilt up the speaker until it is resting on its
bottom. Remove the top piece of foam, and the wrapping. Repeat with
the other speaker, and store the packaging in a dry, safe place – just in
case you need to transport the speakers.
and foam wrapping off. Now, tilt up the speaker until it is resting on its
bottom. Remove the top piece of foam, and the wrapping. Repeat with
the other speaker, and store the packaging in a dry, safe place – just in
case you need to transport the speakers.
1.2 Room Placement
A good starting position for your G6.1e is about 18 inches (46cm) into
the room as measured from the front wall (the wall you look at as you
are seated listening to the speakers) to the back of the base of the
speakers. Place the speakers about five to six feet (1.8 metres) apart
measured between the tweeters. Toe the speakers in slightly towards
the listeners – by about 5 to 10 degrees – no more.
the room as measured from the front wall (the wall you look at as you
are seated listening to the speakers) to the back of the base of the
speakers. Place the speakers about five to six feet (1.8 metres) apart
measured between the tweeters. Toe the speakers in slightly towards
the listeners – by about 5 to 10 degrees – no more.
This is the best starting point for audiophile two channel stereo set-ups.
If you are primarily using these speakers for home theatre enjoyment,
the speakers can be placed nearer to the wall. If you are only going to
use these speakers for stereo, you may want to pull them further away
from the wall.
If you are primarily using these speakers for home theatre enjoyment,
the speakers can be placed nearer to the wall. If you are only going to
use these speakers for stereo, you may want to pull them further away
from the wall.