GE WB48X10055 Manual De Usuario

Descargar
Página de 29
Care and cleaning of the oven. 
Non-Self-Clean Oven Interior 
(on the lower oven)
With proper care, the porcelain enamel
finish on the inside of the oven—top,
bottom, sides, back and inside of the
door—will stay new-looking for years. 
Let the oven cool before cleaning. 
We recommend that you wear rubber
gloves when cleaning the oven.
Soap and water will normally do the 
job. Heavy spattering or spillovers may
require cleaning with a mild abrasive
cleaner. Soap-filled scouring pads may 
also be used.
Do not allow food spills with a high sugar or acid
content (such as tomatoes, sauerkraut, fruit juices
or pie filling) to remain on the surface. They may
cause a dull spot even after cleaning.
Household ammonia may make the
cleaning job easier. Place 1/2 cup in a
shallow glass or pottery container in a
cold oven overnight.
The ammonia fumes will help loosen the
burned-on grease and food.
If necessary, you may use an oven cleaner.
Follow the package directions.
Do not spray oven cleaner on the electrical
controls and switches because it could cause 
a short circuit and result in sparking or fire.
Do not allow a film from the cleaner to build up
on the temperature sensor—it could cause the
oven to heat improperly. (The sensor is located
at the top of the oven.) Carefully wipe the
sensor clean after each oven cleaning, being
careful not to move the sensor as a change in
its position could affect how the oven bakes.
Do not spray any oven cleaner on the oven
door, handles or any exterior surface of the
oven, cabinets or painted surfaces. The cleaner
can damage these surfaces.
20
Safety Instructions
Operating Instructions
Care and Cleaning
Tr
oubleshooting T
ips
Consumer Support
Oven Heating Elements
Do not clean the bake element or the broil
element. Any soil will burn off when the 
elements are heated. 
To clean the oven floor, gently lift 
the bake element. Clean with warm 
soapy water.
Wire cover holder
Oven Light Bulb 
CAUTION: Before replacing your oven light bulb,
disconnect the electrical power to the oven at the
main fuse or circuit breaker panel. 
Be sure to let the light cover and bulb
cool completely.
To remove the cover:
Hold a hand under the cover so it
doesn’t fall when released. With
fingers of the same hand, firmly
push back the wire cover holder. 
Lift off the cover. 
Do not remove any screws to remove the cover.
Replace bulb with a 40-watt
appliance bulb.
To replace the cover:
Place it into grooves of the light
receptacle. Pull wire forward to
the center of the cover until it 
snaps into place. 
Connect electrical power to 
the oven.