Gateway kas303 Manual De Usuario
46
Chapter 3: Using the Receiver
www.gateway.com
Switching between connected
components
components
To switch between connected components:
1
Press the
Input Selector
button on the receiver or press one of the
Direct
Input Selector
buttons on the remote control.
■
The available input source changes are: Tuner, Tape, Aux, Video 1,
Video 2, Video 3, and 7-Direct.
Video 2, Video 3, and 7-Direct.
2
If you selected Aux, Video 1, Video 2, or Video 3, press the
Digital Input
button on the receiver to select the corresponding digital or analog input.
■
The available digital or analog inputs are: A(nalog), o(ptical) 1,
o(ptical) 2, and c(oaxial) 1
o(ptical) 2, and c(oaxial) 1
3
Press the
Decoding
button on the receiver or the
Auto
button on the remote
control to select the decoding mode you want.
■
The available decoding modes are: In-Auto, In-DTS, and In-PCM.
■
You cannot select a decoding mode unless you have also selected a
digital input source.
digital input source.
■
Noise may be generated at the beginning of playback and while
searching when you are in
searching when you are in
In-Auto
decoding mode during DTS
playback. If this happens, switch to
In-DTS
mode.
4
Use the component you selected for playback.
5
Press the up and down
Volume
buttons on the receiver or on the remote
control to adjust the volume.