Gallien-Krueger Artist Series 700RB-11 Manual De Usuario
12
700RB-II/1001RB-II Series
Rear Panel Controls
Rear Panel Controls
1- AC Receptacle:
The power cord is detachable and plugs in here.
2- 700W/480W Amp Only:
700W/480W power amp output for Full-Range
operation only. They deliver 700W/480W into 4
Ohms. Lower impedances should not be used.
Higher impedances such as 8 Ohms, 16 Ohms, or No
Load are acceptable. One 8 Ohm cabinet is okay. One
4 Ohm and one 8 Ohm is not recommended. No
damage will result from operating the amplifier with
the speakers disconnected.
operation only. They deliver 700W/480W into 4
Ohms. Lower impedances should not be used.
Higher impedances such as 8 Ohms, 16 Ohms, or No
Load are acceptable. One 8 Ohm cabinet is okay. One
4 Ohm and one 8 Ohm is not recommended. No
damage will result from operating the amplifier with
the speakers disconnected.
3- “Speakon” Outputs:
Enables BI-AMP operation by connecting a GK-RBH
Series cabinet with the provided 4 conductor Speakon
cable. This connects the Tweeter/50W amplifier
allowing the Tweeter control on the front panel to
control the signal going to the horn. See Bi-Amp and
Normal Operation on page 7 for more information.
Series cabinet with the provided 4 conductor Speakon
cable. This connects the Tweeter/50W amplifier
allowing the Tweeter control on the front panel to
control the signal going to the horn. See Bi-Amp and
Normal Operation on page 7 for more information.
Caution:
Do not connect a Speakon cable labeled “Bridge
Mode” to the 1001RB-II/700RB-II. This may result in
damage to the amplifier.
Mode” to the 1001RB-II/700RB-II. This may result in
damage to the amplifier.
Maximum Recommended Load:
One 4 Ohm or two 8 Ohm cabinets on the Woofer/
Main Amp.
One or two 8 Ohm horns on the 50W Amp.
Main Amp.
One or two 8 Ohm horns on the 50W Amp.
CAUTION:
UNDER NO CIRCUMSTANCES
SHOULD THE WOOFER/MAIN
AMP AND THE 50W/TWEETER
AMP BE CONNECTED TO-
GETHER OR BE CONNECTED
TO THE SAME SPEAKER !!!
2
3
1