GarrettCom - Garrett Communications Door 6K16 Manual De Usuario

Magnum 6K16-Series Managed Fiber Switch Installation and User Guide (04/06) 

 

36

.

.

Step 1.  Make sure the 6KPM Card package has all necessary accessories to install it 

properly. Each 6KPM Card package except the Gigabit, for field installation 

contains (Daughterboard (Bigger) and Granddaughter board (smaller), three 5/8  

stand offs for Granddaughter board, 6 standoff for daughter Board, nine  #4-40 

Pan-Head screws along with Front panel face plate package. The Front panel 

faceplate package includes 2 retainer brackets and four #2-56 flat head screws. 

module separately one by one to avoid the mixing. Do not change the Blue 

 

The Magnum 6K16-Series 

chassis consists of top-bottom, front 

and rear parts and assembled together 

with the help of 18 Philips-head 

screws. There are 6 screws located on 

the front panel of the unit (2 each on 

top and the bottom and one each at 

the side), 12 for  top-bottom cover of 

the unit (6 each on the bottom side of 

the unit) and 6 screws each on the 

sides and 6 screws for the rear panel 

(2 each on top and bott0m and one 

each on the side). Remove these 

screws. Once these screws are removed, the front panel is easily slid out to the front of 

the chassis base.  

Figure 3.6.1a:   Removing the Front panel 

from the unit 

disturb the power supply. 

Once the front panel is removed, the 

front cover may be slid out to the front of the 

unit. Hold on the back part and then carefully 

and slowly slide out the top chassis cover 

towards the front side, as shown in the picture.