Energy Tech Laboratories ETL - Energy Technology Laboratories Blower RSIB 300-500 Manual De Usuario

11

 

A safety system must be interlocked with the appliance. The safety system could utilize a Proven Draft Switch  

(PDS-1), a thermal switch, a flow switch or a sail switch. The device must be interlocked with the heating

appliance(s) so it shuts down in case of insufficient draft, fan failure or power failure. Please refer to

 

the PDS Installation Manual for wiring instructions. 

 

If the installation includes an EBC12 or EBC 30 Fan Control, a PDS-1 is not required as the function is    

 

 

integrated in the control.

 

For more information about alternative safety system, please consult EXHAUSTO. 

 

 

 

Install the probe for the Proven Draft Switch (PDS-1) in the vent connector. The probe must be located between the  

 

appliance and the power venter. The probe must be located at least 3 vent diameters downstream of the draft  

 

 

hood, draft diverter, or barometric damper. The probe placement should also observe distances from elbows and    

Tees as shown in figure below. The tip of the probe MUST be flush with the inner chimney wall to

 

get a proper pressure reading.