Emerson NR290TTC Manual De Usuario

3

Avoid installing this unit in places 
exposed to direct sunlight or close to 
heat radiating appliances such as 
electric heaters, on top of other stereo 
equipment that radiates too much heat, 
places lacking ventilation or dusty areas, 
places subject to constant vibration and/ 
or humid or moist areas.

Do not attempt to clean this unit with 
chemical solvents as this might damage 
the finish. Use a clean dry cloth.

Operate controls and switches as 
described in the manual.

Before turning On the power, make 
certain that AC power cord is properly 
installed.

,

,

Store your Cds, cassettes  in a cool 
area to avoid damage from heat.

When moving the set, be sure to first 
disconnect the power cord.

CLASS 1 LASER PRODUCT

APPAREIL A LASER DE CLASSE 1

PRODUCTO LASER DE CLASE 1

CAUTION

INVISIBLE LASER RADIATION
WHEN OPEN AND INTERLOCKS

DEFEATED.

AVOID EXPOSURE TO BEAM

This equipment has been tested and found to comply with the limits for a Class Bdigital 

device, pursuant to Part 15 of the FCC Rules. These limits are designed toprovide 

reasonable protection against harmful interference in a residentialinstallation. This 

equipment generates, uses, and can radiate radio frequency energyand, if not installed and 

used in accordance with the instructions, may cause harmfulinterference to radio 

communications. However, there is no guarantee thatinterference will not occur in a 

particular installation. If this equipment does causeharmful interference to radio or television 

reception, which can be determined byturning the equipment off and on, the user is 

encouraged to try to correct theinterference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which thereceiver 

is connected.

Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to thefollowing 

two conditions:

This device may not cause harmful interference, and

This device must accept any interference received, including interference that 

may cause undesired operation.

(1)

(2)

Changes or modifications not expressly approved by the party responsible for compliance 
could void the user

s authority to operate the equipment.