Edirol Webcam V-8 Manual De Usuario

 

Here’s how to switch between the images being input to bus A and bus B of the video mixer.

 

* The factory preset settings are assigned to memory number 1. For details on 

 

* When you use the [PC INPUT SELECT] switch to switch the PC input, it will take some time for the input to stabilize. 

We recommend that you use a monitor to verify the image.

* If you want to adjust the display position or other aspects of the PC input screen, refer to “Adjusting the PC Input 

 

Press one of the [1 MIX] [2 WIPE] [3 EFX] buttons to select the desired 
transition. The selected button will light.

* With the factory presets, the TRANSITION buttons are assigned the following transition effects.

* You can change the transition effect that’s assigned to each TRANSITION button. For details, refer to “Changing 

* Depending on the type of transition and effect (p. 42), there are some combinations that cannot be used 

 

To output the bus A image, move the video fader toward bus A.

To output the bus B image, move the video fader toward bus B.

If the video fader is not fully toward the bus A or bus B position, using the INPUT SELECT buttons to switch channels 
will cause the image to be distorted, but this is not a malfunction.

Take the following action and make the following settings before using the INPUT SELECT buttons to switch images. 
This will allow you to switch smoothly between images without any switching noise.

 

•

 

Set the video fader all the way toward the bus A or bus B position (the bus that is outputting the video).

 

•

 

Raise the value of the “Utility” menu item “Input Select Delay Time.”

 

1. Mix (Trans1)

001: Mix01

Dissolve 

 

2. Wipe (Trans2)

008: Wipe03

Wipe

 

3. Efx (Trans3)

192: SWipe88

Soft edge wipe

Bus A

Bus B

Use the [PC INPUT SELECT] switch 
to change between the PC1 and PC2 
connector inputs.

Bus A

Bus B

V-8_e.book 35 ページ ２００８年５月１５日　木曜日　午後１時１１分