Cyclades PR2000 Manual De Usuario
Cyclades-PR2000
29
Chapter 4 - Step-by-Step Instructions
STEP FOUR
The Encapsulation parameters for Frame Relay are less straight-forward. Many of them are based on
decisions that cannot be shown in a diagram. Fortunately, the choices made here will mostly effect the
performance of the link, rather than whether it works or not. Fill in the parameters appropriate for your system,
consulting chapter 8 of the Installation Manual for more information if necessary.
The Encapsulation parameters for Frame Relay are less straight-forward. Many of them are based on
decisions that cannot be shown in a diagram. Fortunately, the choices made here will mostly effect the
performance of the link, rather than whether it works or not. Fill in the parameters appropriate for your system,
consulting chapter 8 of the Installation Manual for more information if necessary.
Menu CONFIG=>INTERFACE=>SWAN=>ENCAPSULATION=>FRAME RELAY
Parameter
Parameter
Example
Your Application
SNAP IP
Inactive for the example. The router on the
sending end must be using the same header
type (NLPID or SNAP) as the router on the
receiving end.
sending end must be using the same header
type (NLPID or SNAP) as the router on the
receiving end.
LMI
ANSI for the example. This must also be
the same as the router on the receiving end.
the same as the router on the receiving end.
T391
Ten seconds, the interval between the LMI
Status Enquiry messages.
Status Enquiry messages.
N391
Six.
N392
Three.
N393
Four. This value must be larger than N392.
CIR
90 percent. 100 minus this number is the
percentage of total bandwidth that may be
discarded if the network is congested.
percentage of total bandwidth that may be
discarded if the network is congested.
Bandwidth Reservation
Inactive. Traffic control will not be covered
in this example
in this example
FIGURE 4.13 FRAME RELAY ENCAPSULATION MENU PARAMETERS
At the end of the parameter list shown above, the DLCI menu appears. Choosing Add DLCI will lead to the
parameters shown in Figure 4.14. The <ESC> key used at any time during the Frame Relay encapsulation
parameter list will also bring up the DLCI menu. A DLCI entry must be created for every remote Frame Relay
network to be contacted. In the example, only one is shown.
parameters shown in Figure 4.14. The <ESC> key used at any time during the Frame Relay encapsulation
parameter list will also bring up the DLCI menu. A DLCI entry must be created for every remote Frame Relay
network to be contacted. In the example, only one is shown.