CycleOps Club Pro 300PT Manual De Usuario

2

A. Insert the handlebar post into the head tube and 
tighten the 6mm pinch bolt or L-Handle.

B. Carefully slide the handlebar onto the handlebar 
post, 

ensuring that the cables are not twisted. 

 Once 

the handlebar is in place, secure it with the quick-re-
lease lever.  The lever must be in the “Closed” position 
in order to safely use the IC.

C. Once the handlebar is properly installed, attach the 
plastic end cap with two of the included Phillips-head 
screws.

A. Open the quick-release lever and slide the seat clamp assembly 
onto the seat tube.  The clamp should be pointing towards the 
front of the CycleOps IC.  Slide the clamp assembly all the way 
forward to allow access to the clamp.  The seat clamp assembly is 
secured to the seat post tube via a quick-release lever.  Secure the 
mechanism by rotating the lever into the “Closed” position prior to 
using the IC.

B. To attach the saddle to the seat post clamp, use a 6mm Allen 
wrench.  Make sure both rails of the saddle are properly seated in 
the clamp and tighten the 6mm Allen bolt.  If desired, you can at-
tach any standard bicycle saddle to the CycleOps Indoor Cycle.  Be 
sure to tighten the saddle so that it is level and parallel to the fl oor 
for optimum comfort.  Note: Seat may need to be retightened after 
fi rst few uses.  Retighten screw for the seat assembly as well as for 
the angle of the seat.

C. Once the Saddle is level and properly tightened in the clamp, 
attach the plastic end cap with two of the included screws.

D. In some instances, a shorter seat post is required for individu-
als under fi ve feet tall.  You can replace the standard seat clamp 
mechanism with part # 16616. Contact Saris Cycling Group to 
order this part.  Follow the instructions provided with that part for 
installation.