Cub Cadet 1400E Manuales De Servicio

• Water hose must be at least 3/4 inch 

in diameter.

• Flow rate of water supply must not fall

below 2.5 GPM (gallons per minute).

• Flow rate can be determined by

running the water for one minute into
an empty 5-gallon container.

• The water supply temperature must 

not exceed 104°F/40°C.

• Never use the pressure washer to draw

in water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.

• Always prevent debris from being drawn

into the unit by using a clean water
source.

Attach one adapter bracket 

to pressure washer by aligning holes on
adapter bracket with posts on the pressure
washer as shown. Tighten the two screws.

Place detergent reservoir between

adapter brackets as shown. Attach second
adapter bracket.

Connect the high pressure hose to

the unit’s high pressure outlet.

Insert the spray wand of

your choice into the wand extension.
Press in against the spring tension and
twist into the locked position.

Connect garden hose 

to unit’s water inlet.

Connect garden hose 

to the cold water source and turn
water on completely.

Plug the power cord into the power

outlet. Trigger the gun to eliminate trapped air,
wait for a steady flow of water to emerge from
the spray nozzle.

Turn on the pressure 

washer (I). The motor starts only if 
the trigger of the gun is pulled 
and shuts off when the trigger is
released. 

Slide the spray wand extension 

into the gun. Turn the wand collar onto the gun
threads until tight.

Attach handle onto top of

adapter brackets. Press down to lock.
Tighten with screws as shown. 
Note: Hose/cord caddy and trigger 
gun holder must be on opposite sides.