Craftsman 14-Inch Band Saw Manual De Propietario

- Check contents against the parts list. 

  

Hint: All front and side panels assemble behind (inside) leg pieces.

- Fasten front panel on to paired legs, using hex carriage bolts, washers and hex nuts. Do not fully tighten.

- Fasten side panel on to front panel and paired leg assemblies using remaining hex carriage bolts, washers and hex nuts.

- Fasten the front and side beams on the paired legs with hex carriage bolts, washers and hex nuts.

- Set stand in an upright position, ensuring that the holes on the top edge of the panels line up sufficiently to allow hex head screws to 

  pass through. Fully Tighten the hex carriage bolts and hex nuts.

- Press rubber feet onto the end of stand legs.

- With the aid of an assistant, lift band saw and carefully position in place on top of stand.

- Install base to stand using hex head screw (11) and washer (10) through stand and saw base, then washer (10) and hex nut (9) on top of 

  saw base. Repeat procedure for all four corners before tightening fully.

 To Avoid back injury, get help lifting the band saw. Bend your knees, and lift with your legs, not your back.

1 

 

Front beam 

 

2

2 

 

Side beam 

 

2

3 

 

Legs 

 

 

4

4 

 

Side panel 

 

2

5 

 

Front panel 

 

2

6 

 

Hex nut   

 

24

7 

 

Washer   

 

24

8 

 

Hex carriage bolt   

24

9 

 

Hex nut   

 

8

10 

 

Washer   

 

8

11 

 

Hex head screw   

4

12 

 

Rubber foot 

 

4

13                         Washer                              

 

4

The 124.32607 band saw is supplied partly assembled. Prior to use, the following items have to be assembled: Open Stand, 2-1/2” Dust 

Port, Table, Blade Tension Knob, Tool Holder, and Crank Handle.

 To avoid injury, do not attempt to run or use this machine until all parts are assembled and working properly.

B. Assemble the 2-1/2” dust port to the band saw frame with Hex 

socket head cap screw and washer. Place the 2-1/2” dust port onto 

the side of the band saw frame.

Locate two Hex socket head cap screws and two washers from the 

bag of loose parts. Mount the dust port to the band saw frame and 

install a Hex socket head cap screw with washer in each hole, then 

tighten with M5 Hex “L” wrench. (See FIG. 1)

C. Assemble the upper table trunnion to the lower table trunnion with 

Carriage Bolt, Glide Piece, Washer and Wing Nut (See FIG. 2).

D. Place the table onto the upper table trunnion. Carefully feed the 

blade through the slot of the table. (See FIG. 2A)