Crestron electronic on wall speaker Manual De Usuario

Crestron Adagio™ AADS  

Audio 

Distribution 

System

Crestron recommends using the latest programming software and that each device 
contains the latest firmware to take advantage of the most recently released features.  
However, before attempting to upload or upgrade, it is necessary to establish 
communication.  

Use Crestron Toolbox for communicating with the AADS; refer to the Crestron 
Toolbox help file for details. There are two methods of communication. 

Direct Serial Communication  NOTE:  Serial Communication must be used for initial setup of Ethernet parameters 

when the out-of-the-box functionality is not used. 

PC RUNNING

CRESTRON TOOLBOX

AADS

SERIAL VIA CRESTRON

CABLE STCP-502

OR EQUIVALENT

 

•  The COMPUTER port on the AADS connects to the serial port on the PC 

via the included serial cable (Crestron STCP-502 or equivalent).  

•  Use the Address Book in Crestron Toolbox to create an entry using the 

expected serial communication protocol (RS232, auto-detect baud rate, no 
parity, 8 data bits, 1 stop bit, XON/XOFF disabled, RTS/CTS enabled).  

•  Display the AADS’ “System Info” window (click the 

 icon); 

communications are confirmed when the device information is displayed.   

 

NOTE:  A connection to an Ethernet network is required for operation with a  
CEN-IDOC, AAS, or any other TCP/IP enabled device. 

PC RUNNING

CRESTRON TOOLBOX

AADS

ETHERNET

 

•  Establish direct serial communications between the AADS and PC. 
•  Enter the IP address, IP mask, and default router of the AADS via Crestron 

Toolbox (Functions | Ethernet Addressing); otherwise enable DHCP.  

NOTE:  When taken out of the box, the AADS is configured for DHCP 
operation. If a DHCP server is available and the AADS is connected to the 
network, the IP address can be obtained from the About screen as described 
on page 30. 

•  57