Crestron electronic AudioExpander Manual De Usuario

Crestron Adagio™ AAE  

Audio 

Expander

8 

SETUP (LED and 

button) 

Used to setup unit’s Net ID in conjunction 
with Crestron Toolbox. 

9 

LOOP THRU 

 

2 un-powered Cresnet ports paralleled with 
NET ports 1-6 (supplied). For connection to 
Adagio control unit or 2-Series control 
system and additional AAE units. 

          

Pin 1  No Connection 

          

Pin 2  (Y)  Data 

          

Pin 3  (Z)  Data 

          

Pin 4  (G)  Ground 

1. 

Refer to “Fuse Replacement” on page 8 for additional details. 

2. 

Refer to “Hardware Hookup”, which begins on page 6 for additional cord details. 

This product is Listed to applicable UL Standards and requirements by Underwriters 
Laboratories Inc.  

      

(E302724)

 

As of the date of manufacture, the Adagio AAE Audio Expander has been tested and 
found to comply with specifications for CE marking and standards per EMC and 
Radiocommunications Compliance Labeling. 

      

 

NOTE:  This device complies with part 15 of the FCC rules. Operation is subject to 
the following two conditions: (1) this device may not cause harmful interference, and 
(2) this device must accept any interference received, including interference that may 
cause undesired operation.  

This equipment has been tested and found to comply with the limits for a Class B 
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference in a residential 
installation. This equipment generates, uses and can radiate radio frequency energy 
and, if not installed and used in accordance with the instructions, may cause harmful 
interference to radio communications. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause 
harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures: 

 

Reorient or relocate the receiving antenna. 

 

Increase the separation between the equipment and receiver. 

 

Connect the equipment into an outlet on a circuit different from that to 
which the receiver is connected. 

 

Consult the dealer or an experienced radio/TV technician for help. 

•  5