Crestron electronic TPS-GA-TPI Manual De Usuario
Isys
®
G-Series Touchpanel Interface
Crestron TPS-GA-TPI
28
• Isys
®
G-Series Touchpanel Interface: TPS-GA-TPI
Operations Guide – DOC. 6501
Video 1 Setup Details – Video, S-Video, Component and RGB (Continued)
VIDEO 1 SETUP
SCREEN
CONTROLS
DESCRIPTION
Color Control
(Continued)
(Continued)
Green
1, 2
Adjusts the amount of green in the video signal. Available
when the RGB Color button is selected.
when the RGB Color button is selected.
Blue
1, 2
Adjusts the amount of blue in the video signal. Available
when the RGB Color button is selected.
when the RGB Color button is selected.
Overscan
3
These controls adjust the amount of video information at the
edges of the image. This part of the video picture is usually
beyond the display capabilities of the screen.
edges of the image. This part of the video picture is usually
beyond the display capabilities of the screen.
None
3
Sets the video screen so there is no overscan. The amount
of used screen area is smallest in this configuration.
of used screen area is smallest in this configuration.
Normal
3
Sets the video screen for normal overscan. This results in
more area of the screen being used.
more area of the screen being used.
Max
3
This sets the video screen area to the maximum. The
screen area is largest in this configuration. All video
information at the edges is visible.
screen area is largest in this configuration. All video
information at the edges is visible.
Size and Position
When RGB is selected as the video source, these controls
are available when the RGB Size and Position button has
been pressed.
been pressed.
Calibration
When Perform Calibration button is pressed, the device
attempts to center the current video signal and find the
correct clock and phase settings. When Auto Mode is
pressed, the device first looks for a preset that matches the
current video characteristics (e.g., resolution, refresh rate,
etc.). If one is found, it is loaded. If one is not found, an
automatic calibration is performed. Manual Mode button
allows manual adjustment.
correct clock and phase settings. When Auto Mode is
pressed, the device first looks for a preset that matches the
current video characteristics (e.g., resolution, refresh rate,
etc.). If one is found, it is loaded. If one is not found, an
automatic calibration is performed. Manual Mode button
allows manual adjustment.
Position
This control allows you to set the position of the video
screen on the touchscreen. The arrow buttons move the
screen along the X and Y axis.
screen along the X and Y axis.
Restore
Default
Position
Position
Returns the video screen to its original position on the
touchscreen.
Size
Allows you to set the size of the video screen in both the
vertical and horizontal directions.
Restore
Default Size
Returns the video screen to it original size on the
touchscreen.
Phase
These controls adjust the phase of the RGB signal. Controls
are shown for both coarse and fine adjustments.
Restore
Default Phase
Returns the video signal to its original default phase.
1.
Video default is zero (0) for each of the video parameters (brightness, contrast, red, green and blue).
2.
Adjustment applies to the currently selected video source only.
3.
These controls are available only in Video, S-Video and Component modes. In RGB mode they are
analogous to the Position, V Size and H Size controls.
analogous to the Position, V Size and H Size controls.