Futaba 10CAG Manual De Instrucciónes

117

Rx: receiver.

SAFE MODE

: feature in snap roll programming that does not allow a snap roll if landing gear is lowered. See Snap roll.

Sailplane: glider, non-powered model aircraft type. See GLID

MODEL TYPE.

Select a model: see MODEL SELECT.

Service Center.  .......................................................................................................................................................................  3

SERVO

EDUJUDSKGLVSOD\RQVFUHHQWRVKRZUHDOWLPHPRYHPHQWFRPPDQGVVHQWWRVHUYRVE\WUDQVPLWWHULQUHVSRQVHWR

user movements. Also includes a servo test feature. ............................................................................................................  49 

Servo reversing: see REVERSE.

Servo Slow: see Channel delay.

Servo testing, servo display: See SERVO.

SET

: to accept. Usually done by pressing and holding the dial when instructed.

Slave: channel that moves in response to the command of the master. See Programmable mix.

Slaving servos: see programmable mix. .............................................................................................................................  68

Slider assignability: sliders on side of radio, known as VR(D) and VR(E) in programming, may be assigned to control 
channels 5-8 in AUX-CH, used as the primary control of a mix in programmable mixes, etc.

Slow: see Channel delay.

Smoke system: injects a specialized smoke oil into the hot exhaust to create air-show like smoke trails.  .........................  74 

SNAP ROLL

: (ACRO

FRPELQHVUXGGHUHOHYDWRUDQGDLOHURQPRYHPHQWWRFDXVHWKHDLUFUDIWWRVQDSRUVSLQDWWKHÀLSRID

switch. 10CG offers four separate snaps with one or two switches used for selection.  ......................................................  59 

6SHHG)ODSVPDLQÀDSVRQD¿YHVHUYRJOLGHU

SPOILER MIX

 (GLID

PRYHVWKHVSRLOHUVE\ÀLSSLQJWKHDVVLJQHGVZLWFKDQGLVXVHGWRPDNHVWHHSGHVFHQWV$QGSPOILER

MIX

 works linking with BUTTERFLY function.  ....................................................................................................................... 83

START DELAY

  (GLID 1A+1F only): automatically switch the offset trims (OFFSET) from the START condition's trims to the 

normal cndition's trims after proceeding the delay time (max.10sec.) which is preset when activating the START condition. 
It is convenient for hand launch glider. ................................................................................................................................  85

Stick adjustments: change stick tension and height. ............................................................................................................  16 

STk-THR: assigned to THROTTLE STICK. See AIRBRAKE for example. 

SUB-TRIM

XVHGWR¿QHWXQHWKHFHQWHURUQHXWUDOSRLQWRIHDFKVHUYR$OORZVIXOOWULPIXQFWLRQIURPWKHWULPVOLGHUVIRU

ÀLJKWWULPPLQJ .................................................................................................................................................................... 49 

SWASH AFR

: (HELI, CCPM types only) adjustment of the travel of all servos involved in the particular controlis movement 

only during the movement of that control. Ex: reverse the direction of movement of collective pitch while not affecting the 
direction of movement of either cyclic control. ...................................................................................................................  95 

Swashplate type: (HELI

3DUWRIWKHPRGHOW\SHVHOHFWLRQSURFHVV6HOHFWVVSHFL¿FKHOLVZDVKSODWHJHRPHWU\VXFKDVRQHRI

four available types of "CCPM."  ......................................................................................................................................... 95 

SWASH-RING

 (HELI

OLPLWVWKHVZDVKSODWHWUDYHOWRZLWKLQD¿[HGUDQJH .......................................................................... 96 

SWASH-THR

 (HELI): is corrected the tendency of the model to change altitude when the rotor is tilted by aileron, elevator, 

and other controls. ................................................................................................................................................................  85 

Switch programmability: MOST features are reassignable to a variety of switches, including simply moving an auxiliary 
FRQWUROVXFKDVÀDSVIURPWKHVWRFNGLDOWRDVZLWFKRURWKHUORFDWLRQ6HHAUX-CH.