Futaba 10CAG Manual De Instrucciónes
81
AILE
RUDD(GLID):
Adjustability:
• RATE range of -100 to +100. Negative setting would result in opposite rudder (aileron) action from aileron (rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. Set up LOGIC SW: See p. 38.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the mix in 2 separate
• RATE range of -100 to +100. Negative setting would result in opposite rudder (aileron) action from aileron (rudder).
• SWITCH A-H fully assignable. Also LOGIC SW (Lsw1 to 3) may be assigned. Set up LOGIC SW: See p. 38.
• POSITION fully assignable, including NULL (mix always on) and Up&Cntr and Cntr&Dn to activate the mix in 2 separate
positions of the same SWITCH.
• Condition: The separate AILE
RUDDVHWWLQJVIRUHDFKÀLJKWFRQGLWLRQFDQEHVHW
GOAL of EXAMPLE:
STEPS:
INPUTS:
([ 58''ĺ$,/( QR VZLWFK
corrects roll coupling.
corrects roll coupling.
Open AILE
RUDD mix submenu.
for 1 second.
(If BASIC,
again.)
to 2nd page of menu.
C
to AILE
RUDD.
Select the mixing mode.
C
to MODE.
to RUDD
ĺAILE
Activate the function.
C
to MIX
to ON.
Set the rate. (Ex: 100% each way)
C
to FLP1.
RUDDER STICK.
to +25%.
RUDDER STICK.
to +25%.
Repeat as needed.
Close.
Where next?
ELEV-FLAP
mixing. See p. 62.
BUTTERFLY
. See p. 63.
Use a mix to OFFSET
WKHÀDSVDVHWGLVWDQFHRQDVSHFL¿HGVZLWFK VHHS
View additional model setups on the internet: www.futaba-rc.com\faq\
You can select a pre-programed mix which is used to mix the rudders with
aileron operation or the ailerons with rudder operation.
Aileron-to-rudder mix (AILE
aileron operation or the ailerons with rudder operation.
Aileron-to-rudder mix (AILE
ĺRUDD): automatically creates a "coordinated turn".
Rudder -to-aileron mix (RUDD
ĺAILE): used to counterract undesirable roll (roll
coupling) that happens with rudder input, especially in knife-edge.