Country Home Products DR ALL-TERRAIN FIELD and BRUSH MOWER Manual De Usuario



ALL-TERRAIN



FIELD and BRUSH MOWER Safety & Operating Instructions

Unpacking the Mower

NOTE:

Unpacking the DR



ALL-TERRAIN



FIELD and BRUSH MOWER is a

two-person job. We recommend you have an extra set of hands available
before you begin.

Tools & Supplies Needed:

• screwdriver
• hammer
• knife
• gloves

1. Stand to one side and cut the banding.
2. Remove the top of the carton. Cut the cardboard top to bottom on one of the

narrow sides of the box and peel it off the pallet. Be careful of the staples.

3. Pry off the fasteners and cut any ties holding the machine to the pallet.
4. Remove the brush deck by lifting it up and over the supporting lumber, and then

remove the lumber. You may need to remove one of the cross slats. At this point
the lawn deck (if ordered) is free standing and can be lifted off the pallet.

5. Roll the power unit off the pallet.
6. Attach the deck to the power unit following the directions on the next page. The

belt is stored below the black pulley cover.

7. If assembling the Lawn Deck, mount the front caster wheels before attaching the

deck to the power unit.

Note:

The Safety and Operating Instructions and the caster wheels for the Lawn Deck (if

ordered) are tucked in one of the cardboard corner supports.

WARNING!

The banding may have a lot of tension on it and may snap,

cutting you when cut. Always stand to one side when cutting the band.

WARNING!

Before attaching the deck, be sure the spark plug wire(s) is

disconnected.

Caution:

Wear gloves and be very careful when handling the deck(s). The

blades are very sharp, and may spin as you maneuver the deck(s).