Furuno DP-6 Manual De Usuario
5-2
3. Input frequency pair. This can only be done with FURUNO
transceivers.
For other makes of transceiver, set a frequency pair at the trans-
ceiver. Omit steps 1, 2 and 3.
ceiver. Omit steps 1, 2 and 3.
4. Press the [Enter] key.
5. Press function key [F3] again and then the [9] key. The follow-
ing screen appears.
Mode
:
ARQ
FEC
ID :
Manual Calling
Figure 5-3 Manual calling screen
6. Select communication mode.
7. Press the [ ] key and input party's ID number.
8. Press the [Enter] key to connect the communication line. Then,
the line will be connected a short while.
For ARQ mode, follow the next procedure. For FEC mode,
type your message and go to step 13.
type your message and go to step 13.
9. Press function key [F7] (WRU). The party's answerback code
appears on the screen.
Note:
Step 9 and 10 are needed for ship to ship calling only.
10. Press function key [F8] (HR). You ship's answerback code is
sent to the party.
11. Press the [Enter] key and type your message.
12. If you want to the party's response, press function key [F9]
(Over).
13. Press function key [F10] to disconnect the line.