Fujitsu IRMC S2/S3 Manual De Usuario
240
iRMC
S2/S3
Network Settings - Configure the LAN parameters
V
CAUTION!
Contact the network administrator responsible for the system before you
change the Ethernet settings.
change the Ethernet settings.
If you make illegal Ethernet settings for the iRMC S2/S3, you will only be
able to access the iRMC S2/S3 using special configuration software, the
serial interface or via the BIOS.
able to access the iRMC S2/S3 using special configuration software, the
serial interface or via the BIOS.
I
Only users with the
Configure iRMC S2/S3 Settings
permission are allowed
to edit Ethernet settings (see
).
Network Interface Settings
MAC Address
The MAC address of the iRMC S2/S3 is displayed here.
LAN Speed
LAN speed. The following options are available:
–
Auto Negotiation
–
1000 MBit/s Full Duplex (depending on the server hardware)
–
100 MBit/s Full Duplex
–
100 MBit/s Half Duplex
–
10 MBit/s Full Duplex
–
10 MBit/s Half Duplex
If
Auto Negotiation
is selected, the onboard LAN controller assigned to the
iRMC S2/S3 autonomously determines the correct transfer speed and
duplex method for the network port it is connected to.
duplex method for the network port it is connected to.
LAN Port
I
This option is not supported for all PRIMERGY servers.
On some PRIMERGY server models, the LAN interface of the installed
system NIC (network interface card) can be set up
system NIC (network interface card) can be set up
–
as shared LAN for shared operation with the system
or
–
as a service LAN for exclusive use as a management LAN.