Fujitsu CM71-00329-7E Manual De Usuario
52
CHAPTER2 Dependence Functions
2.1.10.2
Setting Trace
You must set the following two items to perform a trace. After that, trace data will be
sampled with the execution of the program. You can set this from the command
window.
sampled with the execution of the program. You can set this from the command
window.
■ Setting Trace
1. Enable the trace function
- This is done by [Setup] - [Trace] in the trace window shortcut menu. This program will startup and
will be enabled.
2. Set the trace buffer full break
- When the trace buffer is full, you can make a break. This is done using the setting dialogs of the
trace window shortcut menu [Setup] - [Trace].
- When starting up this program, it is setup for no breaks.