Compatible Systems IntraPort Enterprise-8 Manual De Usuario
Chapter 6 - Basic Configuration Guide
24
IPX Protocol
Required for IPX
Generally, there are no required changes from the shipping Ethernet configuration for IPX. The
Ethernet interface will autoconfigure to use the two most common IPX frame types, and will
automatically adapt to conditions on the Ethernet.
Ethernet interface will autoconfigure to use the two most common IPX frame types, and will
automatically adapt to conditions on the Ethernet.
Suggested for IPX
You may want to set your own network numbers, rather than using the autoconfigured values.
You may also want to turn off unused frame types.
You may also want to turn off unused frame types.
CV: Use the IPX Routing: Ethernet Dialog Box for Ethernet 0:0, 2:0, 4:0, and 6:0.
TB: Use
configure and set keywords in the IPX Ethernet 0:0, IPX Ethernet 2:0, IPX
Ethernet 4:0 and IPX Ethernet 6:0 sections.
AppleTalk Protocol
Required for AppleTalk
Generally, there are no required changes from the shipping Ethernet configuration for Apple-
Talk. The Ethernet interface will autoconfigure to use AppleTalk Phase 2, and will adapt to
conditions on the Ethernet.
Talk. The Ethernet interface will autoconfigure to use AppleTalk Phase 2, and will adapt to
conditions on the Ethernet.
Suggested for AppleTalk
You may want to set your own network numbers, rather than using the autoconfigured values.
You may also want to use more meaningful zone names.
You may also want to use more meaningful zone names.
CV: Use the AppleTalk Routing:Ethernet Dialog Box for Ethernet 0:0, 2:0, 4:0, and 6:0.
TB: Use configure and set keywords in the AppleTalk Phase 2 Ethernet 0:0, AppleTalk
Phase 2 Ethernet 2:0, AppleTalk Phase 2 Ethernet 4:0 and AppleTalk Phase 2
Ethernet 6:0 sections.
Ethernet 6:0 sections.
Configuring the Server for LAN-to-LAN Tunnels
Required for LAN-to-LAN Tunnel Configurations
LAN-to-LAN tunneling requires that you set parameters for a VPN port on each end of a
tunnel, so you must repeat this setup on the remote end.
tunnel, so you must repeat this setup on the remote end.
•
Partner IP address
•
Bind To interface
CV: Add a VPN Port using the File menu and selecting VPN Port/Add VPN Port. Then use
the Tunnel Partner: VPN port number Dialog Box for the port(s) you created to set these
parameters.
parameters.
TB: Use configure and set the Partner and BindTo keywords in the Tunnel Partner VPN
port number section.
Suggested for LAN-to-LAN Tunnel Configurations
It is recommended that you also set authentication and encryption parameters for each tunnel.
CV: Use the Tunnel Partner: VPN port number Dialog Box for the port you created to set
these parameters.
TB: Use configure and set keywords in the Tunnel Partner VPN port number section.