Compaq W25 Manual De Usuario

 

Note if the proxy[x].address is set to “localhost”, the W25 will not register to 
any SIP server. 

To display the entries in the call server, use the following command  

ims.callserver[0].domain "server.com" 
                 .proxy[0].address "host.server.com" 
                          .port 5060 
                 .outbound_proxy "" 
                 .local_ip_interface "ppp0"           

The domain parameter is for future use. The proxy[x].port is by default 5060 
(according to the SIP standard). The port number only needs to be 
changed in special case. 

In a normal scenario the SIP server is accessible via the WAN interface, 
but for test and demo purposes it’s possible to use a SIP server which is 
connected on the LAN interface. To change this you need to modify 
“local_ip_interface” from “ppp0” (WAN) to “br0” (LAN).   

The IMS Media Codec commands configure the settings for T.38. 

The settings for T.38 are used for Fax. The following parameters can be 
configured: 

Specifies if FEC (Forward Error Detection) should 
be used or otherwise Redundancy packets will be 
used. (True|False) 

The max bit rate for fax transmission. Valid values 
are 2400, 4800, 7200, 9600, 12000 and 14400. 

Defines whether the tcf (Training Check Flag) 
should be local i.e. only between the fax machine 
and the W25 T.30-client or end to end (to the 
terminating fax machine). If using UDP (default) 
this parameter should be set to false.  (True|False) 

Capability to remove and insert fill bits in Phase C, 
non-ECM data to reduce bandwidth in the packet 
network. (True|False) 

Specifies whether the ability to convert to/from 
MMR from/to the line format for increasing the 
compression of the data and saving bandwidth in 
the packet network. (True|False) 

Specifies whether the ability to convert to/from 

12 

2/221 02-FGB 101 327 Uen B – November 2007