Classe Audio Surround Sound Processor SSP-800 Manual De Usuario
26
Connect the Main Analog Audio Outputs, either RCA or XLR, from the
rear panel of the SSP-800 to the corresponding inputs on your amplifi er(s) as
follows:
rear panel of the SSP-800 to the corresponding inputs on your amplifi er(s) as
follows:
• Connect the SSP-800 Front Left and Front Right outputs to the
inputs of the amplifi er(s) designated for the Front Left and Front
Right speakers, respectively.
Right speakers, respectively.
• Connect the SSP-800 centre output to the input of the amplifi er
designated for the centre channel speaker.
• Connect the SSP-800 Left Surround and Right Surround outputs to
the inputs of the amplifi er(s) designated for the Left Surround and
Right Surround speakers, respectively.
Right Surround speakers, respectively.
• If you are setting up a 7.1-channel system, then also connect the
SSP-800 Left Rear and Right Rear outputs to the inputs of the
amplifi er(s) designated for the Left Rear and Right Rear speakers,
respectively.
amplifi er(s) designated for the Left Rear and Right Rear speakers,
respectively.
• If you are using a subwoofer, connect the SSP-800 subwoofer output
to the input of the designated amplifi er or powered subwoofer.
NOTE: Make sure connections from the subwoofer output go only to an
amplifi er connected to a subwoofer, as low frequency signals can damage a
small full-range speaker not designed for high output bass reproduction.
amplifi er connected to a subwoofer, as low frequency signals can damage a
small full-range speaker not designed for high output bass reproduction.
Verify that each cable is clearly labeled so that you don’t mix them up. When
connecting a cable, make sure the cable has a good connection and is fi rmly
attached to the rear panel connectors on both the amplifi er and the SSP-800.
connecting a cable, make sure the cable has a good connection and is fi rmly
attached to the rear panel connectors on both the amplifi er and the SSP-800.
Th
e SSP-800 also provides two Auxiliary analog audio outputs. See the Rear
Panel section for more details about the Auxiliary outputs.
Step 5
Connect the loudspeakers to the amplifiers.
Important!
Verify that the power amplifier(s) is plugged in but powered
OFF before connecting to the SSP-800!
OFF before connecting to the SSP-800!
Connect each loudspeaker to its designated amplifi er(s) channel. Pay close
attention to the phase of the speaker connections – always connect an amplifi er’s
red (+) terminals to the red (+) terminals of the loudspeaker. Likewise, connect black
(–) terminals to black (–) terminals.
attention to the phase of the speaker connections – always connect an amplifi er’s
red (+) terminals to the red (+) terminals of the loudspeaker. Likewise, connect black
(–) terminals to black (–) terminals.