Cisco Systems 2140 Manual De Usuario

To power up a Cisco ADE 2130 and 2140 Series appliance with a DC power supply and verify its 
initialization and self-test, follow this procedure. When the procedure is finished, the appliance is ready 
to configure.

If a redundant power supply is used, separate DC power sources are needed for each power supply. This 
allows you to turn off power for one power supply without affecting the power source for the other.

Review the information in the 

Plug the Molex terminal block connector into the power connector located on the rear right-hand side of 
the appliance. (See location 1 in 

Connect the DC power input wires to the DC power source at your installation site.

Press the power button on the front of the appliance. (See location 9 in 

The appliance should begin its powerup procedure. 

After the operating system boots up, observe the front-panel LEDs to verify that your system is operating 
properly. (See 

 and the 

.)

Once the operating system boots, you are ready to initialize the basic software configuration. (See the 
software installation guide or user guide that shipped with your appliance, for proper configuration 
procedures.)

When the Cisco ADE 2130 and 2140 Series appliance is up and running, observe the front-panel LEDs. 
(See 

.)

Appliance power LED

ID control switch (push button)

Appliance status LED

NMI (nonmaskable interrupt) recessed 
button

1

Hard disk drive activity LED

Reset push button

NIC activity (all NICs)

Appliance power push button

Appliance system ID LED

A

B

C

D

E

H

F

I

G

231190