Cisco Systems 2140 Manual De Usuario

The following procedures assume your Cisco ADE 2130 and 2140 Series appliance came shipped with 
the front bezel installed.

Remove the front bezel to:

install or remove hard drives or the optional DVD-ROM drive

access the front-panel serial (console) port and USB ports

observe the individual hard disk drive (HDD) activity and fault LEDs

The appliance does not need to be powered down to remove the front bezel.

To remove the front bezel:

Unfasten the bezel retention screw on the right side of the appliance with a Number 2 Phillips 
screwdriver.

Rotate the bezel outward and detach.

To install the front bezel:

Align the four tabs on the left of the bezel with the slots in the front panel and then rotate the free end 
of the bezel to the closed position.

Snap the front bezel into place and tighten the screw at the right side of the bezel.

The hard drives are hot-swappable. Before removing or replacing a hard drive, you do not need to take 
the Cisco ADE 2130 and 2140 Series appliance out of service.

Up to six drives can be installed. The hard drive bay is at the left side of the appliance chassis, underneath 
the DVD-ROM drive. The hard drive trays in the drive bay are labeled 1, 3, and 5 on the left side of the 
bay and 0, 2, and 4 on the right side of the bay (see 

). The drives need to be 

installed in a specific order; that is, drive 0 must be installed before drive 1, drive 1 before drive 2, and 
so on.

If you install fewer than six hard drives, the empty bays must have drive trays with baffles in them to 
maintain proper appliance cooling.