Cisco Systems 2.7 Manual De Usuario
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
Setting Up AAA Servers
5-26
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16345-01
To enable monitoring of an ACS server, you must:
•
Configure CiscoSecure ACS server to recognize the WLSE as a client. Follow
the procedure in this section on each server.
the procedure in this section on each server.
Note
If two Ethernet interfaces are configured with IP addresses on the
WLSE, both addresses must be configured as clients on ACS server.
WLSE, both addresses must be configured as clients on ACS server.
•
Configure the WLSE to add information about servers. For more information,
see
see
.
In addition to monitoring AAA servers, you can use an AAA server to
authenticate to Wireless Domain Services (WDS) access points. To enable this
authentication, make sure an AAA server is configured as described in this
section, and configure WDS as described in
authenticate to Wireless Domain Services (WDS) access points. To enable this
authentication, make sure an AAA server is configured as described in this
section, and configure WDS as described in
Procedure
Step 1
Log into the CiscoSecure ACS Server that will provide authentication services to
the wireless network.
the wireless network.
Note
You will need the IP address or name of the system on which CiscoSecure
ACS Server is running when you configure the WLSE.
ACS Server is running when you configure the WLSE.
Step 2
Click User Setup on the left side of the initial page.
Step 3
Enter a username for the user the WLSE will use for synthetic transactions and
click Add/Edit.
click Add/Edit.
Step 4
Enter a password in the first set of Password and Confirm Password fields. Click
Submit.
Submit.
Note
You will need this name and password when configuring the WLSE.
Step 5
Click Network Configuration on the left side of the page.