Char-Broil THE BIG EASY 7101366 Manual De Usuario

8  •  07101366

CAUTION

WARNING

•   

1. Turn ON LP gas cylinder.

2. Press and turn the control knob to HIGH.

3. Turn ROTARY IGNITOR knob rapidly.

4. If ignition does not occur in 5 seconds, turn the burner control 

knob OFF, wait 5 minutes, and repeat lighting procedure.

• Turn control knob to 

position. Turn LP cylinder off by 

turning hand-wheel clockwise to a full stop.

• Turn gas off at LP cylinder. Turn ignitor knob. "Click" should 

be heard each time at electrode. See "Troubleshooting" if no 
click or spark.

checking valve.  Knob locks in 

position. To check valve, 

first push in knob and release, knob should spring back. If knob 
does not spring back, replace valve assembly before using Oil-
less Fryer. Turn knob to

 HIGH position then turn back to 

position. Valve should turn smoothly.  

• Before each use, check to see if hose is cut, worn or kinked. 

Replace damaged hose before using applaince. 

• 

Meat Thermometer: Do not immerse or soak in water. Wash 

with warm soapy water and wipe dry.

• Do not mistake brown or black accumulation of grease and 

smoke for paint.  Interiors are not painted at the factory 

should never be painted). Apply a strong solution of detergent 

and water or use a grill cleaner with scrub brush on insides of 
appliance lid and bottom. Rinse and allow to completely air dry. 

surfaces. 

• 

Plastic parts: Wash with warm soapy water and wipe dry.
Do not use citrisol, abrasive cleaners, degreasers or a 
concentrated grill cleaner on plastic parts. Damage to and 
failure of parts can result. 

• Painted surfaces: Wash with mild detergent or non-abrasive 

cleaner and warm soapy water. Wipe dry with a soft non-
abrasive cloth.

• Stainless steel surfaces: To maintain the high quality 

appearance, wash with mild detergent and warm soapy water 
and wipe dry with a soft cloth after each use. Baked-on grease 
deposits may require the use of an abrasive plastic cleaning 
pad. Use only in direction of brushed finish to avoid damage. 
Do not use abrasive pad on areas with graphics.

OFF  

• Light burner, rotate knob from 

HIGH to LOW. Looking through 

viewing hole on top of appliance, you should see the flame 
height decrease  when turning knob from 

HIGH to LOW.  

Always check flame prior to each use. If only low flame is seen 
refer to "Sudden drop or low flame" in the Troubleshooting 
Section.

Normal
Hose

Kinked
Hose

s

 

1. Turn ON LP cylinder.

2.  Swing match hole plate to expose match lighting hole.  Place 

lit match into match lighting hole of appliance as pictured 
below.  Make sure lit match is placed inside hole and near 
burner.

3. Push in and turn control knob to HIGH. Be sure burner lights 

and stays lit.

4.  Once lit, swing match hole plate back to cover up match 

lighting hole.  Caution: Plate maybe hot.