Casio ACS V6000 Manual De Usuario
Parameter
Description
Enable Auto Discovery
The target name will be discovered and will be associated with this
serial port. If it fails, the Port Name will be used. Default: Disabled.
serial port. If it fails, the Port Name will be used. Default: Disabled.
Protocol
The protocol that will be used to access the serial port/target. SSH -
Authorized users can use SSH to connect to the console of a
connected device. Telnet - Authorized users can use Telnet to connect
to the console of a connected device. SSH/Telnet - Authorized users
can use SSH and/or Telnet to connect to the console of a connected
device simultaneously. Raw - Authorized users can make a Raw
Socket connection to the console of a connected device. Default:
SSH/Telnet.
Authorized users can use SSH to connect to the console of a
connected device. Telnet - Authorized users can use Telnet to connect
to the console of a connected device. SSH/Telnet - Authorized users
can use SSH and/or Telnet to connect to the console of a connected
device simultaneously. Raw - Authorized users can make a Raw
Socket connection to the console of a connected device. Default:
SSH/Telnet.
Authentication Type
Authentication type that will be used to authenticate the user during
target session. Default: Local.
target session. Default: Local.
Text Session Hot Key
Hotkey to suspend the target session and go to the CLI prompt. Not
available for Raw. Default:
Ctrl-Z
. NOTE: The default escape
character for ts_menu is
Ctrl-X
.
Power Session Hot Key
Hotkey to suspend the target session and display Power Management
Menu to control the power state of the target. Not available for Raw.
Menu to control the power state of the target. Not available for Raw.
Default:
Ctrl-P
. NOTE: The default escape character for ts_menu is
Ctrl-X
.
TCP Port Alias
For a Telnet/Raw session: TCP port to connect directly to a serial port.
For SSH session: Alias of the port similar to ttySxx. Default: 70XX,
where XX is the serial port number.
For SSH session: Alias of the port similar to ttySxx. Default: 70XX,
where XX is the serial port number.
Port IPv4/IPv6 Alias
IPv4/IPv6 address used to connect directly to a serial port. Default: not
configured (empty).
configured (empty).
Port IPv4/IPv6 Alias
Interface
Interface
Interface (ETH0) associated with the IPv4/IPv6 alias.
Allow Session Only if
DCD is On
DCD is On
When the DCD is OFF, the appliance will deny access for this serial
port. Default: Disabled (allow access if DCD is OFF).
port. Default: Disabled (allow access if DCD is OFF).
Enable Auto Answer
When the input data matches one input string configured in Auto
Answer, the output string will be transmitted to the serial port. Default:
Disabled.
Answer, the output string will be transmitted to the serial port. Default:
Disabled.
DTR Mode
DTR Mode can be set to the following: Always On. Normal - the DTR
status will depend on the existence of a CAS session. Off Interval -
when the a CAS session is closed, the DTR will stay down during this
interval. Default: Normal.
status will depend on the existence of a CAS session. Off Interval -
when the a CAS session is closed, the DTR will stay down during this
interval. Default: Normal.
30
ACS v6000 Installation/Administration/User Guide