Carrier Access Network Device Axxius 800 Manual De Usuario

The Control Panel Interface card provides front access to all the physical interfaces of 
the DS1 or DS3 Controller cards. It provides four RJ-48C DS1 connections when using 
the DS1 Controller and two sets of DS3 SMB interfaces when using the DS3 
Controller. Additionally, the Control Panel Interface Card provides the RS-232 and 
10/100Base-TX Ethernet management connections for system configuration and 
control. Status indicators are provided for critical, major, minor, and ACO alarm relay 
status, and an Alarm Cut Off (ACO) Switch is also provided to silence external audible 
alarms.

Note: In the event of a power failure to the unit (5V in the backplane), there are relays 
that will cut 1 to 3 and 2 to 4. These relays are hard-wired to +5V, so al long as there is 
power, the cut-through does not happen (there is no software control of this feature).

l

24 or 48 VDC power options

l

High service availability through circuit protection, redundancy, remote 
provisioning and hot-swappable service cards

l

All cards hot-swappable

l

Supports fully protected Ring, Star, and Cascade network topologies

l

High interface density and versatility. 8 service slots for: T1, V.35 
10/100Base-T Ethernet, RS-232, POTS, OCU-DP, FXO and ISDN BRI service 
cards and Terminal Server Router card for 10/100Base-TX Ethernet

l

Simplified installation with front access modular or rear wire-wrap connectors

l

19 or 23 inch rack mountable, 2 RU, passively cooled 

l

10 user-defined alarm inputs

l

Audio and visual alarm outputs

l

Primary and secondary BITS clock inputs for external timing source

l

Operating temperature ranges -40 to 149 ºF (-40 to 65 ºC)