Carrier Access Network Device Axxius 800 Manual De Usuario

There are three power supplies available with the Axxius 800; 24 VDC and 48 VDC 
and 48 VDC NI, all use this connector. The Axxius 800 supports a redundant power 
system, therefore there is INPUT (power) P1 and P2. 

A separate 

fuse should be used for each DC input

If two power supplies are installed into the system they MUST be 

of the same type (24 VDC, 48 VDC or 48 VDC NI).

1. Ensure that no power is present on the two wires to be connected.

2. Strip the two wires from the power source so that approximately 5/16 inch of 

bare wire is exposed. 16

 

or

 

18

 

AWG

 

insulated

 

copper

 

wire

 

is recommended 

for power

 

connections.

3. Insert the Battery Return and DC wires into the appropriate square holes, one 

at a time.

4. Tighten screws to clamp wires.

24 VDC

5 Amp 

7 Amp

48 VDC/48 VDC NI

2.5 Amp

3.5 Amp