Canicom 200 Manual De Usuario
CANICOM 200 – User’s guide – May 2009
6/12
IMPORTANT: before beginning the coding (first use of the receiver or re-coding), make sure no
other person is using his CANICOM 200 or other products from the DOGTEK range close by: your
receiver collar could accidentally record the code of his remote control. If that occurs, re-code
the remote control with the receiver collar.
CODING PROCEDURE FOR THE 1
ST
USE
1. Activate the remote control: press for 1 second the On/Off red button ( ) located on the side of
the remote control.
2. Activate the receiver collar: approach the red mark located on the remote control until coming in
contact on red mark located on the receiver for 1 second.
3. Move the remote control away from the receiver collar.
4. Press the button of the remote control. A beep sound is emitted, the receiver collar is then
4. Press the button of the remote control. A beep sound is emitted, the receiver collar is then
synchronized with your remote control.
RE-CODING PROCEDURE (for all codings except the 1
st
one)
1. Activate the remote control: press for 1 second the On/Off red button ( ) located on the side of
the remote control.
2. Receiver collar in position « deactivate » (indicator light off): approach the red mark located
on the remote control until coming in contact on red mark located on the receiver collar for 6
seconds.
The indicator on the collar lights in fixed green, then flashes in red.
3. Move the remote control away from the receiver collar.
4. Press the button of the remote control. A beep sound is emitted, the receiver is then synchronized
4. Press the button of the remote control. A beep sound is emitted, the receiver is then synchronized
with your remote control.
Reprogram a receiver collar
The receiver collar can be re-coded indefinitely,
either with the same remote control, or with a new remote
control from the CANICOM range. Ref. § Re-coding procedure.
● How to use the remote control
The CANICOM 200 remote control is designed to operate with 1 receiver collar. For optimal range
performance, hold the remote control in front of you with your arm extended, at least 10 inches away
from your body. Do not cover the top of the remote control unit or antenna with any part of your hand
while holding.
button: beeper
If you press the « Beeper » button the receiver collar will emit sound signals. There is no time limit for
this function: the beeper will continue to sound as long as you press the button.
A « transmission » symbol will appear on the LCD screen of the remote control; the indicator light goes
from flashing green to permanent green as long as you press the button.
It is up to you to use the beeper depending on the way you want to train your dog. With the beeper you
can:
- send a sound to your dog when it is disobedient,
- draw its attention, ...
It’s very important to always use the beeper in the same way in order not to disturb your dog.
F button: Flash stimulation
Press the «F» button to send a warning to your dog using stimulations transmitted by two contact points
located on the receiver collar for a defined length of time of less than one second.
A « transmission » symbol will appear on the LCD screen of the remote control; the indicator light goes
from flashing green to permanent red as long as you press the button.
C button: Continuous stimulation
Press the «C» button to send a warning to your dog using stimulations transmitted by two contact points
located on the receiver collar, the duration will be as long as you press the button but limited to 8
seconds maximum.
Nota: Beeps can be associated to the stimulations by pressing first the “C” button and then the button.
Nota: Beeps can be associated to the stimulations by pressing first the “C” button and then the button.