Cabletron Systems CSMIM-T1 Manual De Usuario
Commands
CSMIM-T1 Hardware Installation Guide
7-3
%A
n
Auto-Reliable Fallback Character
Where n is an integer between 0 and 127 indicating an ASCII
character (Default is 0, auto-reliable fallback character disabled).
character (Default is 0, auto-reliable fallback character disabled).
Sets the ASCII character recognized as the auto-reliable fallback
character on the answering modem. In auto-reliable mode, when
the modem encounters an incoming auto-reliable fallback
character from the remote system, it automatically switches to
normal mode and passes the character to the serial port.
Auto-reliable fallback character recognition stops if the modem
receives a SYN character (decimal 22).
character on the answering modem. In auto-reliable mode, when
the modem encounters an incoming auto-reliable fallback
character from the remote system, it automatically switches to
normal mode and passes the character to the serial port.
Auto-reliable fallback character recognition stops if the modem
receives a SYN character (decimal 22).
\A
n
Maximum MNP Block Size
\A0
Sets block size up to a maximum of 64 characters.
\A1
Sets block size up to a maximum of 128 characters.
\A2
Sets block size up to a maximum of 192 characters.
\A3
Sets block size up to a maximum of 256 characters.
Sets maximum block size for MNP stream link connections.
B
n
ITU-T/Bell Mode
B0
Uses ITU-T V.22 and V.21 standards at 1,200 and 300 bps.
B1
Uses Bell 212A and 103 standards at 1,200 and 300 bps.
$
B
n
Serial-Port Bps Rate
Where n = 75; 300; 600; 1,200; 2,400; 4,800; 9,600; 19,200;
38,400; 57,600; 115,200 bps.
38,400; 57,600; 115,200 bps.
Sets the serial-port bps rate when issued.
!
CAUTION
Do not set n=63 or n=126. These settings interfere with V.42
negotiations.
negotiations.
NOTE
With this command, \ N3 \ C2 must also be set.