Cabletron Systems CSMIM-T1 Manual De Usuario

Chapter 2: INSTALLING THE CSMIM-T1

At the monitor prompt,

If necessary, execute the erase command to clear the EEPROM. (See 
the erase command in Chapter 3.)

Execute the addr command to enter CSMIM-T1 operating parameters 
described in Section 3.2, such as IP address, Ethernet address, Subnet 
Mask, Broadcast address, Preferred Load Host and Dump Host.

Execute the boot command (see the boot command in Chapter 3).

If the boot is successful, then the following LED’s will be on:

Modem Config LED’s (Green)

STAT LED (Green)

Ethernet Channel Indicator LED (Green)

ON LINE LED (if T-1 line is connected)

If the boot is unsuccessful, the red ATTN LED will flash, and a message 
will display on the monitor.

If you are loading software for the first time on a new unit, it is 
not necessary to erase the EEPROM. To do so will erase the 
EFS Key information, and you will have to reload it manually. If 
you have not recorded the key information and erase the 
EEPROM, you will have to call Cabletron Customer Service 
with your PO number to get a new one. For the reloading 
procedure, see Section 2.7.3 Reloading the EFS Key.

The erase command will also delete the LAT key, which is 
obtained separately from the EFS Key. Please make sure you 
have stored these keys in a safe place.

The CSMIM-T1 takes 4 to 5 minutes for a normal boot over the 
network, depending on traffic.