Cabletron Systems CSMIM-T1 Manual De Usuario

Chapter 3: ROM Monitor Commands

The console-baud command changes the console port’s baud rate. Thus, 
the console port can interface with any modem to which it is connected. 
When the baud rate is entered as auto, the CSMIM-T1 detects the baud 
rate of the incoming line and adjusts its baud rate accordingly. This 
command provides support for remote troubleshooting. The command 
syntax is:

The command display looks like this:

To provide remote access to the CSMIM-T1 ROMs:

From a site local to the CSMIM-T1:

Set the CSMIM-T1 into test mode so the monitor prompt appears 
on the console.

Set the modem into auto-answer mode.

This command has no effect on the port’s baud rate after the 
CSMIM-T1

 is booted

monitor::

 

Remote Diagnostic Test Mode

In order to use the remote diagnostic functionality, you
must first connect a modem to the console port of the
Annex. The modem should be configured such that DTR is
forced on, carrier detect and DSR are set normal, and
auto-answer is enabled. Once this is done, contact your
service representative for remote diagnostic maintenance.

To enter “Autobaud Mode”, please type “Auto”. To
“manually” configure the Annex console port, please type
in the desired baud rate. To return to the “monitor::”
prompt strike the “carriage return <CR>” key.

[Baudrate Range: 50-9600 BAUD]

Select Baudrate []::