Audiovox RCA RIR200 Manual De Usuario

13

Before you begin

General controls of RCA Wi-Fi Enabler 
(for RIR205)

WAN

LAN

RESET

POWER

PRESS

WPS

Antenna 

Power 
adapter jack

Reset push 
button

WAN port – connect to your 
existing access point, 
broadband modem or 
Ethernet router/hub/switch

•  LAN port – if your modem or 

router/hub/switch has only 
one LAN port and is 
connected to your PC, 
disconnect the Ethernet cable 
from the modem/router/hub/
switch and connect it to the 
Enabler's LAN port. 

•  You can also connect it to your 

computer's Ethernet port to 
access the Enabler's web-
administration page for 
troubleshooting purposes. 
Refer to page 31 for more 
information.

To turn on the Wi-Fi Enabler:
The Enabler will turn on automatically when power 
is connected. 

To check the RCA Wi-Fi Enabler's status by 
reading the LEDs (Lights):
•  Normally the POWER, WAN and WIRELESS LEDs 

will be on when the enabler is operating as a 
router.

•  The LAN LED will be on if there is an Ethernet 

cable connected from the LAN port on the 
Enabler to a computer.

•  The MODE LED will be off when the Enabler is 

operating as a Router.

•  The MODE LED will be on when the Enabler is 

operating as an (AP) Access Point.

To rescan the network configuration:
•  Your Wi-Fi Enabler comes preconfigured from the 

factory so normally no rescan should be 
necessary. 

•  Press and hold the WPS key for 3 seconds. The 

MODE LED then starts blinking. This will indicate 
to the user that the unit is scanning the network 
to determine the correct mode for the new 
environment (i.e. either router or AP).

•  If during a scanning, the unit cannot determine 

the mode or needs more information (i.e. no 
response from the WAN connection, PPPOE, fixed 
IP address connection, etc) the unit will start 
flashing the MODE, WPS and WIRELESS LEDs.

To reset the Enabler:
•  If you are unable to connect the radio to the 

Wi-Fi enabler, press and hold the RESET for 10 
seconds to reset the Wi-Fi enable back to factory 
defaults. After resetting the Wi-Fi enabler, try 
connecting again.

To install the Enabler:
The Enabler can be installed vertically or 
horizontally. Remove the standing brackets for 
horizontal installation. Rotate the antenna to 
improve signal reception.

PRESS

WPS

PRESS

WPS

Frequently asked questions

For answers to frequently asked questions (FAQ's), 
go to www.rcainfiniteradio.com.