Atari 040-0050-01 Manual De Usuario

 

Section 2  –  Cabinet Conversion 

 

 

© 2004 GLOBAL VR

®

, INC. 

040-0050-01

 Rev. A 10/29/2004 

 

Page 17 of 48 

3. Set 

jumper 

J8 on the Jamma conversion board to pins 1 and 2 for stereo, or pins 1 and 3 

for mono audio, depending on how your cabinet audio is set up. 

4.  Place the boards next to each other in the service tray where you removed the old boards.  

Make sure that the Jamma connector on the Jamma wire harness can reach the Jamma 
Conversion Board before securing the boards to the cabinet.  

5.  Secure the boards with wood screws in the plastic feet. 

Connect the Jamma Conversion Board and UVC 

 

Refer to the figure above, and Figure 5, Simplified Wiring Diagram, on page 43, and perform 
the following steps to connect the Jamma harness wiring and other cables to the Jamma 
Conversion Board: 

1.  Connect the Jamma connector from the Jamma harness to the Jamma edge on the Jamma 

Conversion Board.  

2.  Connect the Video Input, J4 on the Jamma Conversion Board to the video output port on 

the Video Converter board, if used, or to the VGA port on the computer video card.  

3.  Connect the existing PC power supply in the cabinet to the Jamma Conversion Board 

PWR IN port using the PC Y-power cable from the kit.  

Note:  The PC Y-power cable uses a standard PC power supply connection found on 
most DC power supplies used in arcade cabinets.  If your existing power supply does not 
have this type of connector, you will need to splice the Y-Power cable into the power 
supply on the cabinet.  Here are the specifications for the PC Y-power cable: 
•  Red Wire 

•  Yellow Wire    

•  Black Wire