Atari 040-0050-01 Manual De Usuario

Section 2  –  Cabinet Conversion  

gvrSX™ Conversion System Manual 
Page 22 of 48  

 

040-0050-01

  Rev. A 10/29/2004

 

Upgrade the Control Panel 

Perform the steps in this section to upgrade the old control panel with new buttons, joystick, 
and graphics. 

Prepare the Control Panel 

1.  Disconnect the wires from the buttons and other controls. 

2.  Remove the nuts and bolts that hold the plastic cover to the control panel surface.   

3.  Remove the buttons, trackball (or other controls), the clear plastic cover, and artwork 

from the control panel.   

4.  Install the joystick in the control panel using the four nuts and bolts removed from the 

trackball assembly.  You may need to remove the handle from the joystick to install the 
control panel artwork and plastic cover.   

Apply Control Panel Graphics 

Refer to the picture of the finished control panel, Figure 4, as you place the graphics on the 
control panel.  The exact position of each sticker will depend on the size and shape of your 
control panel, but the finished control panels should look like Figure 4. 

 

Note:  To aid in placing graphics, spray the cabinet surfaces with soapy water or spray 
cleaner before applying each graphic.  This allows you to reposition the graphic easily.  Once 
you are satisfied with placement, use a squeegee to force the liquid out from under the 
graphic. 

1.  Set the background graphic over the control panel and determine placement.  Once you 

are satisfied with the placement, peel off the backing and apply the graphic. 

2.  Using a new Exacto

®

 knife, use the outside edge of the control panel as a guide to cut off 

the excess control panel background graphic material. 

3.  Cut the excess graphic material from the button and joystick holes.