Adtran 220T1 Manual De Usuario
960 Stewart Drive Sunnyvale, CA 94085 USA Phone +1.408.331.3300 +1.877.80SHORE Fax +1.408.331.3333 www.ShoreTel.com
- 17 -
Click on the “Current System Clock Source” link, this action will bring up the “System > Clock Source” page:
Set the “Primary Clock Source:” and “Backup Clock Source:” to “Internal” for both options, then click on the
“Apply” radio button. You will get the message “
Settings applied successfully
”.
Eth 0/2 Interface Configuration
We will now configure the external / WAN Ethernet interface, this will be the interface that Bandwidth.com will
send calls to. You will need to navigate to the “Configuration for “Ethernet 0/2”” page, you can do so either from
the “System Summary” page, where you will need to scroll to the bottom of the page (Ethernet Summary) and click
on the interface name “eth 0/2”. Or from the “Physical Interfaces” page, click on the interface name of “eth 0/2”,
both of these pages are available under the “System” pull down menu on the left hand side of the Adtran Web UI.
The “Configuration for “Ethernet 0/2”” page will look as follows:
We will now configure the external / WAN Ethernet interface, this will be the interface that Bandwidth.com will
send calls to. You will need to navigate to the “Configuration for “Ethernet 0/2”” page, you can do so either from
the “System Summary” page, where you will need to scroll to the bottom of the page (Ethernet Summary) and click
on the interface name “eth 0/2”. Or from the “Physical Interfaces” page, click on the interface name of “eth 0/2”,
both of these pages are available under the “System” pull down menu on the left hand side of the Adtran Web UI.
The “Configuration for “Ethernet 0/2”” page will look as follows: