Digimerge DHU104 Manual De Usuario

Appendix 7: Replacing the Hard Drive

The system comes with a pre-installed, security-grade 3.5" SATA Hard Drive, however the unit 
will work with a replacement single SATA Hard Drive (up to 1 TB).

NOTE: Make sure that the system is OFF and the power cable has been disconnected before 
changing the Hard Drive.

To replace the current hard drive:

1. Remove the four screws on the side panles and three screws on the rear panel. Carefully 

remove the metal housing.

2.  Disconnect the power and data cables from the hard drive. Press the metal clip on each 

cable and gently pull.

3.  Remove the four screws holding the hard drive into the drive bracket.

4.  Place the new drive on the drive bracket and replace the four screws. Make sure the 

connector pins are facing toward the cables.

5.  Reconnect the power and data cables. The metal clip on each cable should be facing up. 

Press the metal clip and gently push the cable until you hear a “click.”

6.  Replace the metal housing and secure with the three screws on the rear panel and four 

screws on the side panels.

Press the metal clip and gently pull each cable.