Delta Electronics DELTA DUP-B Manual De Usuario
Chapter 3 Creating and Editing Screens
Revision May, 2010
3-127
Property Description of Pipe (1) / Pipe (2) Elements
Low Region Color
High Region
Color
This option is available and displayed in the property table only
when the “Ranges” option in the Detail Setup dialog box is selected.
If the user sets the low limit value is 20 and the color of low limit
region is in green, and then set the high limit value is 80 and the
color of high limit region is in red, the pipe element will be shown as
the figures below:
when the “Ranges” option in the Detail Setup dialog box is selected.
If the user sets the low limit value is 20 and the color of low limit
region is in green, and then set the high limit value is 80 and the
color of high limit region is in red, the pipe element will be shown as
the figures below:
When the value is 20 When the value is 50 When the value is 80
X
Used to set X coordinate
Y
Used to set Y coordinate
Width
Used to set the element width
Height
Used to set the element height
3.8.5.2 Pipe(3)
Property Description of Pipe (3) Element
It is used to connect to water pipe element. Pipe (3) element is shown as the figure
below:
below:
Pipe Gauge:
Use this option to set the pipe gauge. The selectable range is from 1 ~ 5. The setting
value 1 represents at least 13 pixels and the setting value 2 represents at least 26
pixels and vise versa.
Use this option to set the pipe gauge. The selectable range is from 1 ~ 5. The setting
value 1 represents at least 13 pixels and the setting value 2 represents at least 26
pixels and vise versa.
X
Used to set X coordinate
Y
Used to set Y coordinate