Davis 6322 Manual De Usuario
Preparing the ISS for Installation
3
The steps to prepare the ISS for installation are:
• Assemble the anemometer.
• Check the factory-installed sensor cable connections to the SIM.
• Connect the anemometer sensor cable to the SIM.
• Apply power to the ISS and test communication with the console.
• Change the Transmitter ID for wireless communication, if necessary.
• Check the factory-installed sensor cable connections to the SIM.
• Connect the anemometer sensor cable to the SIM.
• Apply power to the ISS and test communication with the console.
• Change the Transmitter ID for wireless communication, if necessary.
Assemble the Anemometer
The anemometer measures wind direction and speed. The anemometer arm comes
partially assembled with the wind vane attached. The anemometer arm requires assembly
before it can be assembled with the rest of the ISS.
partially assembled with the wind vane attached. The anemometer arm requires assembly
before it can be assembled with the rest of the ISS.
Please locate the following parts to prepare the anemometer:
• Anemometer arm (wind vane and cable already attached)
• Anemometer base
• Wind cups
• Allen wrench (0.05")
• #4 machine screw, #4 tooth-lock washer, #4 hex nut
• Anemometer base
• Wind cups
• Allen wrench (0.05")
• #4 machine screw, #4 tooth-lock washer, #4 hex nut
Attaching Anemometer Arm to Base
1. Insert the anemometer arm into the base, sliding the cable through the notch in the
base as shown in illustration.
2. Be sure to line up the small hole in the arm with the holes in the base.
3. Insert the machine screw through the holes in the base and arm.
3. Insert the machine screw through the holes in the base and arm.
Slide cable
through notch
Important:
Press cable
firmly
into channel
Insert
anemomter arm
into base
Hex Nut
#4 Tooth
Lock Washer
#4 x 1-1/8"
Machine
Screw
07395.249 Manual ISS Installation_RevE_Final_Print.pdf 5
4/7/2008 1:44:48 PM