BMW 2008 650i Coupe Manual De Propietario

nolo

r co

mfort

, c

nve

e an

Start the engine, but do not start driving.

Select "Reset" and press the controller.

Select "Yes" and press the controller.

Start to drive.
The message "resetting FTM …" is dis-
played.

The initialization is completed during driving.

Indication of a flat tire

The warning lamp lights up in red. A
message appears on the Control Dis-
play. In addition, an acoustic signal

sounds. There is a flat tire or extensive inflation
pressure loss.

Cautiously reduce the vehicle speed to
below 50 mph/80 km/h. Avoid severe brak-
ing and steering maneuvers and do not
exceed a speed of 50 mph/80 km/h.

Stop driving if the vehicle is no longer
equipped with run-flat tires, as it was

when it came from the factory, refer to
page

214

. Continued driving after a flat tire

can result in serious accidents.

Check the air pressure in all four tires at the
next opportunity.

If the tire inflation pressure in all four
tires is correct, the Flat Tire Monitor

may not have been initialized. The system
must then be initialized.

In the event of complete tire pressure loss,
0 psi/0 kPa, you can estimate the possible
distance for continued driving on run-flat
tires, based on the following guide values:

With low load:
1 to 2 persons without luggage:
approx. 155 miles/250 km.

With medium load:
2 persons, cargo bay full, or
4 persons without luggage:
approx. 94 miles/150 km.

With full load:
4 persons, luggage compartment full:
approx. 30 miles/50 km.

Drive reservedly and do not exceed a
speed of 50 mph/80 km/h. In the

event of pressure loss, vehicle handling
changes. This includes reduced tracking
stability in braking, extended braking dis-
tances and altered natural steering charac-
teristics.
If unusual vibrations or loud noises occur
while the vehicle is being driven, this can
indicate final failure of the damaged tire.
Reduce speed and stop at a suitable loca-
tion as soon as possible; otherwise, pieces
of the tire could become detached and
cause an accident. Do not continue driving,
but instead contact your BMW center.

TPM Tire Pressure Monitor*

The concept

TPM checks the tire inflation pressure in the
four mounted tires. The system reports when
the tire inflation pressure has dropped consid-
erably in one or several tires.

Functional requirement

In order to assure the reliable reporting of a flat
tire, the system must have been reset with the
correct tire inflation pressure.
Always use wheels with TPM electronics, oth-
erwise fault-free operation of the system is not
ensured.

Reset the system again after each correc-
tion of the tire inflation pressure and after

every tire or wheel change.