BMW 2005 X3 3.0i SAV Manual De Propietario
![BMW](https://files.manualsbrain.com/attachments/59bff3c21d02c686320f922a23b4f0fd8e167e8d/common/fit/150/50/d22aabf2d062b824edd261b72ebf0e854c720c7e6ff4ab10933d93100f3a/brand_logo.png)
Driving
38
To use the automatic function again, move the
selector lever to the right into position D.
selector lever to the right into position D.
Malfunction
The warning lamp lights up. A malfunc-
tion has occurred in the transmission
system. Avoid heavy loads.
tion has occurred in the transmission
system. Avoid heavy loads.
While it will still remain possible to move the
selector lever to any desired position, the trans-
mission will revert to its default mode with only
a limited number of forward gears.
Have the system checked as soon as possible.
Information on towing and jump starting, refer
to page
selector lever to any desired position, the trans-
mission will revert to its default mode with only
a limited number of forward gears.
Have the system checked as soon as possible.
Information on towing and jump starting, refer
to page
.
Turn signals/headlamp
flasher
1 High beams
2 Headlamp flasher
3 Turn signals
2 Headlamp flasher
3 Turn signals
Atypically rapid flashing of the indicator
lamp indicates that a turn signal bulb has
lamp indicates that a turn signal bulb has
gone out. After the ignition is switched off,
make sure that the roadside parking lamps have
not been left on.
make sure that the roadside parking lamps have
not been left on.
<
Signaling briefly
Press lever to resistance point and hold for as
long as you wish to signal.
long as you wish to signal.
Washer/wiper system/
rain sensor*
0 Wipers retracted
1 Intermittent or rain sensor operation
2 Normal wiper speed
3 Fast wipe
4 Brief wipe
5 Select interval time or set sensitivity of rain
1 Intermittent or rain sensor operation
2 Normal wiper speed
3 Fast wipe
4 Brief wipe
5 Select interval time or set sensitivity of rain
sensor
Fold-out position
The right wiper is partially concealed by the
hood.
To move the wipers into a vertical position:
hood.
To move the wipers into a vertical position:
1.
Switch on wipers in lever position 1.
2.
When the wipers are approximately vertical,
move the ignition key to position 0.
move the ignition key to position 0.
For changing the wiper blades, refer to page
Fold the wipers back down onto the wind-
shield before you turn the ignition key to
shield before you turn the ignition key to
position 1 or 2 again. If you do not, they could be
damaged.
damaged.
<
Intermittent mode
Not on vehicles with rain sensor.
You can set the wipe interval to four stages with
the serrated dial
You can set the wipe interval to four stages with
the serrated dial
5.
In addition, the wipe interval is varied automati-
cally depending on road speed.
cally depending on road speed.
Online Edition for Part-No. 01 41 0 158 448 - © 09/04 BMW AG