BMW 2005 330i Sedan Manual De Propietario

 93

The integrated universal remote control can 
replace as many as three hand-held transmit-
ters for various remote-controlled devices, 
such as door openers and house alarm sys-
tems. The integrated universal remote control 
registers and stores signals from the original 
hand-held transmitters.
The signal of an original hand-held transmitter 
can be programmed on one of the three mem-
ory buttons

1. After this, the programmed 

memory button

1 will operate the system in 

question. The LED

2 flashes to confirm trans-

mission of the signal.
Should you sell your vehicle one day, be sure to 
delete the stored programs beforehand for your 
safety, refer to page

94

.

To prevent possible damage or injury, 
before programming or using the inte-

grated universal remote control, always inspect 
the immediate area to make certain that no peo-
ple, animals or objects are within the pivoting or 
travel range of the device being operated. Com-
ply also with the safety instructions supplied 
with the original hand-held transmitter.

<

If this symbol appears on the package 
or in the instructions supplied with the 
original hand-held transmitter, you can 

assume that the radio remote control device will 
be compatible with the integrated universal 
remote control.

If you have additional questions, please 
consult your BMW center or call 1-800-

355-3515.
You can also visit these websites: 
www.bmwusa.com or 
www.homelink.com. 

HomeLink is a registered trademark owned by 
Johnson Controls, Inc.

<

1 Memory buttons
2 LED

1.

Switch on the ignition, refer to page

.

2.

When starting operation for the first time: 
Press both outer memory buttons

1 for 

approx. 20 seconds until the LED

2 flashes. 

All stored programs are cleared.

3.

Hold the original hand-held transmitter at a 
distance of approx. 2 to 8 in/5 to 20 cm from 
the memory buttons

1.

The required distance between the 
hand-held transmitter and the mem-

ory buttons

1 depends on the system of the 

respective original hand-held transmitter 
used.

<

4.

Simultaneously press the transmit key on 
the original hand-held transmitter and the 
desired memory button 

1 on the integrated 

universal remote control. The LED 

2 flashes 

slowly at first. As soon as the LED

2 flashes 

rapidly, release both buttons. If the LED

2 

does not flash rapidly after approx. 15 sec-
onds, alter the distance.

5.

To program other original hand-held trans-
mitters, repeat steps 3 and 4.

Online Edition for Part-No. 01 41 0 159 259 - © 03/05 BMW AG